John Lewis JLBIGGH755 Manual do Utilizador descarregar pdf (Página 9)

1

1

The by-pass screw

– If you change from natural gas 20

mbar to liquid gas, fully tighten the

by-pass screw in.

– If you change from liquid gas to

natural gas 20 mbar, undo the by-

pass screw approximately 1/4 of a

turn (1/2 of a turn for Triple Crown

burner).

Warning! Make sure the flame does

not go out when you quickly turn the

knob from the maximum position to

the minimum position.

Electrical connection

• The electrical work necessary to install

the appliance must be done by a qualified

electrician or competent person,

according to the current regulations.

•

The appliance must be earthed.

• Always use a correctly installed

shockproof socket.

• Make sure that there is access to the

mains plug after the installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• The appliance must not be connected

with an extension cable, an adapter or a

multiple socket. There is a risk of fire.

Make sure that the ground connection

complies with the standards and

regulations force.

• The power cable must not touch any hot

parts.

• The electrical installation must have an

isolation device which lets you disconnect

the appliance from the mains at all poles.

The isolation device must have a contact

opening width of minimum 3 mm.

• You must have the correct isolation

devices: line protecting cut-outs, fuses

(screw type fuses removed from the

holder), earth leakage trips and

contactors.

• The connection cable parts must not be

heated to a temperature above 90°C.

Electrical Requirements

Permanent electrical installation must

comply with the latest I.E.E. Regulations and

local Electricity Board regulations. For your

own safety the installation must be done by

a qualified electrician (e.g. your local

Electricity Board, or a contractor who is on

the roll of the National Inspection Council

for Electrical Installation Contracting

[NICEIC]).

The manufacturer declines any

liability if these safety measures are

not observed.

The appliance must be connected to a 230 V

50 Hz AC electrical supply.

Before activating the appliance, make sure

the electrical supply voltage is the same as

that indicated on the rating plate. The rating

plate is located on the bottom of the

appliance.

The appliance is supplied with a 3 core

flexible supply cord with a 3 amp plug. If it is

necessary to change the fuse, use a 3 amp

ASTA-approved (BS 1362) fuse.

9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comentários a estes Manuais

Sem comentários