John Lewis JLWM1200 Manual do Utilizador

1200 spin washing machineJLWM 1200User manual

Programme DialIt allows you to switch the appliance on/offand/or to select a programme.Available options:SpinBy pressing this button you can change th

First use• Ensure that the electrical and waterconnections comply with theinstallation instructions.• Remove the polystyrene block andany material fro

Daily useLoad the laundryOpen the door by carefully pulling the doorhandle outwards. Place the laundry in the drum,one item at a time, shaking them ou

corresponding button. The green pilot light ofthe button 5 starts to flash.The selector dial can be turned either clockwiseor counterclockwise. Turn t

Start the programme by pressingbutton 5To start the selected programme, press thebutton 5, the corresponding green pilot lightstops blinking. The pilo

3. Reduce the spin speed if needed, bypressing the relevant button.4.Press button 5.At the end of the programme, the door can benow opened. Turn the p

Helpful hints and tipsSorting out the laundryFollow the wash code symbols on each garmentlabel and the manufacturer’s washinginstructions. Sort the la

Degrees of water hardnessWater hardness is classified in so-called“degrees” of hardness. Information on hardnessof the water in your area can be obtai

Washing ProgrammesProgramme - Maximum and MinimumTemperature - Cycle Description - Maximum SpinSpeed - Maximum Fabrics Load - Type of LaundryOptionsDe

Programme - Maximum and MinimumTemperature - Cycle Description - Maximum SpinSpeed - Maximum Fabrics Load - Type of LaundryOptionsDetergentCompartment

ContentsSafety information 3Children and vulnerable people safety 3General Safety 3Safety instructions 5Installation 5Electrical connection

Programme - Maximum and MinimumTemperature - Cycle Description - Maximum SpinSpeed - Maximum Fabrics Load - Type of LaundryOptionsDetergentCompartment

Programme - Maximum and MinimumTemperature - Cycle Description - Maximum SpinSpeed - Maximum Fabrics Load - Type of LaundryOptionsDetergentCompartment

Technical dataDimensions WidthHeightDepthDepth (Overall dimensions)60 cm85 cm60 cm63 cmElectrical connectionVoltage - Overall power - FuseInformation

Consumption valuesThe data of this table are approximate.Different causes can change the data:the quantity and type of laundry, thewater and ambient t

Care and cleaningWarning! You mustDISCONNECT the appliancefrom the electricity supply,before you can carry out anycleaning or maintenance work.Descali

Cleaning the drawer recessHaving removed the drawer, use a small brushto clean the recess, ensuring that all washingpowder residue is removed from the

• Remove any objects from the pump impellerby rotating it.• Put the cap back on the emergency emptyinghose and place it back in its seat.• Screw the p

4. Screw the hose back onto the tap.5. Unscrew the hose from the machine. Keepa rug nearby because some water may flow.6. Clean the filter in the valv

InstallationUnpackingAll transit bolts and packing must be removedbefore using the appliance.You are advised to keep all transit devices sothat they c

5. Open the porthole and pull out all itemsfrom the drum. Remove the polystyreneblock fitted on the door seal.6. Fill the smaller upper hole and the t

Safety informationBefore the installation and use of the appliance, carefully read thesupplied instructions. The manufacturer is not responsible if an

carried out by a competent person, or qualifiedplumber.Water inletWarning! This appliance must beconnected to a cold watersupply.The inlet hose is scr

1. Into a drainage standpipeFirstly form a hook in the end of the drain hoseusing the “U” piece” supplied.1Place the drain hose into your standpipe, w

Important! Before connecting up themachine to new pipework or to pipeworkthat has not been used for some time,run off a reasonable amount of water tof

Warning! THIS APPLIANCEMUST BE EARTHED.The manufacturer declines anyliability should this safetymeasure not be observed.Before switching on, make sure

What to do if…Certain problems are due to lack of simplemaintenance or oversights, which can be solvedeasily without calling out an engineer. Beforeco

Problem Possible cause/SolutionThe machine does not emptyand/or does not spin:The drain hose is squashed or kinked (the button 5 red light blinks).• C

Problem Possible cause/SolutionThe machine vibrates / Themachine is noisy:The transit bolts and packing have not been removed.• Check the correct inst

Repairs - After Sales ServiceYour appliance comes with a three yearwarranty.If it is not working correctly; consult the faultfinding guides within thi

Environment concernsThe symbol on the product or on itspackaging indicates that this product may not betreated as household waste. Instead it should

John Lewis, Oxford Street 020 7629 7711Peter Jones, Sloane Square 020 7730 3434John Lewis, Brent Cross 020 8202 6535John Lewis, Kingston 020 8547 3000

• If the supply cord is damaged, it must be replaced by themanufacturer, its service agent or similarly qualified persons inorder to avoid a hazard.•T

192994595-A-102013

Safety instructionsInstallation• Remove all the packaging and the transitbolts.• Keep the transit bolts. When you move theappliance again you must bl

• Use this appliance in a householdenvironment.• Obey the safety instructions on the detergentpackaging.• Do not put flammable products or items thata

Product description1Detergent dispenser drawer2Control panel3Door opening handle4Rating plate5Drain pump6Adjustable feet1 235461200 spin washing machi

Detergent dispenser drawer Compartment for detergent used forprewash and soak phase or for stain removerused during the stain action phase (if availab

Control panelBelow is a picture of the control panel.It shows the programme selector dialas well as the buttons and pilot lights.These are presented b