John Lewis SBSKITE Manual do Utilizador

SBSKITBSide by SideInstruction manual

10• Fix the joining bracket (6) with four 4.2x13 self-tapping screws (3) (bag (3) using the holes in the top of thesides, see Fig. (A).• The bracket m

11• If it is necessary to amend the level of the doors, or one single door, partially unscrew the hinge screws,related to the door to be adjusted, and

12• Before proceeding with the assembly of the top remove the protective film from the panel (7).• Position the top with the doors open so that the bo

13• Fix the top frontaly with three M5X12 screws (1) (bag (1), see Fig. (A).• Fix the back of the top with four 4.2x13 self-tapping screws (3) (bag (

14• Fit the trim “11” between the two units by pressing along the entire profile, see figure below.

15• Before proceeding with the fixing of (9,10) side strips remove the protective film.• Insert the side strip, see fig. (A) • Align the outside of t

16• Fit the handle of the cooler appliance, as shown in figures A, B and C.• The pivots and grub screws are included in the handle-kit.• Screw the two

17• Fit the handles of the wine and freezer compartment, as shown in figures A, B, C and D.• The screws and grub screws are included in the handle-kit

18Plumbing In• The appliance has an inlet hose, with female 3/4" BSP thread connector. If this connection is not compatiblewith the plumbing of t

19

2Important information• Do not install the unit on your own or have unqualified personnel install it.• Improper installation may result in damage, mal

You should also ensure that air can circulate freely around the back and the top of the cabinet.Position the assembled Side by Side:• At least 150 mm

21• After the positioning of the appliance, verify the right position with a level.• If necessary regulate the front feet to level the appliances. See

22• Before proceeding with the fixing of the plinth (8) remove the protective film.• Fit the plinth (8) so that the inner hook couples with the joinin

2221 055-9002/09John Lewis Partnership171 Victoria StreetLondon SW1E 5NNwww.johnlewis.com

3Tools required for installation(not supplied)

4

5

6

7• Carefully place the unit on the floor, following the instructions on the packaging to make sure the unit isfacing upwards.• Open the bottom part of

8• Glue the spacer sponge on the right side of the wine cooler-freezer, using the distances indicated in the fig.under neath.

9CBA• Bring the units near to each other.• If necessary adjust the front feet so that the units are both the same height, see Fig. (A).• Insert joinin